FULL TUT ON MINI SMOOCHIEE E01,e07,3W IR,AND RECIVER

@zx_tech

17.7K followers · usually 18.3K views a post

Views

149.6K

Likes

14.1K

Comments

231

Shares

718

SoundTikTok sound · original sound - c4rl_editz1

Promoted product

Mini Smoochiee E01, E07, 3W IR, and Receiver

Why it worked

The video provides a detailed, step-by-step tutorial on how to build a custom electronic device, appealing to hobbyists and makers. The use of on-screen text to guide the viewer through the soldering and assembly process makes it easy to follow, and the clear demonstration of each stage likely drives engagement and shares within the tech and electronics communities.

Summary

This video demonstrates the assembly of a custom electronic device, the "Mini Smoochiee," which appears to be a receiver with IR capabilities. It shows the process of soldering various components, including antenna connectors, an ESP32 S3 microcontroller, IR components, and buttons onto a perfboard, followed by flashing custom firmware.

Structure

1Introduction to the Mini Smoochiee device
2Demonstration of IR circuit and battery circuit diagrams
3Showing components and wiring for SD card and GPS
4

Original caption

like up this tut took hours make #techtok #electronics #Tech #engineering #project

More from @zx_tech

Product placement

The video shows the assembly of a custom electronic device called "Mini Smoochiee" which includes an ESP32 S3 microcontroller, E01 and E07 modules, an IR transmitter and receiver, an SMA antenna connector, and a screen. The assembly process is detailed step-by-step.

Call to action

go on uchiha madara tool and flash code

On-screen text

FULL TUT ON MINI SMOOCHIEE E01,e07,3W IR,AND RECIVER ir circuit solder to these battery circuit buttons bw16 esp 3.3/5v vcc gnd pb2 pb1 gru 5 4 sd card and gps SD esp vcc 3.3v Gnd Gnd Sck 10 mosi 11 miso 8 CS 7 GPS esp vcc 3.3v/5v Gnd Gnd TX 5 (Rx) RX 4 (Tx) cut out perfboard 21x10 holes solder antenna connectors solder esp32 s3 as this solder e01 and e07 glue down get sma to sma antenna connector cut 1 end strip black plastic split wire into 2 equal parts solder to connector solder ir cut screen edge and sand solder pins remove plastic solder as close to perfboard bend pins up solder buttons (resistor not necessary) custom fw has internal pull-up solder the gnd of buttons solder screen and buttons to esp BRUCE S3 SUPERMINI TFT 1.47 GO ON UCHIHA MADARA TOOL AND FLASH CODE OPEN PROJECT REMOVE PROJECT FLASH AGAIN